Lumenier TX5GA 5.8GHz Adjustable RF Power (25-600mw) FPV Transmitter
Package Included
1x transmitting unit (VTX) TX5GA
1x antennas (2db)
1x Heat Sink with 3M adhesive
1x power/ video cable
*Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty. Mount the VTX in an area with good air cooling. It's recommended to apply the included heatsink when using the transmitter in 600mW mode.
Summary
The Lumenier TX5GA Adjustable RF Power (25 - 600mW) 5.8GHz 32CH FPV video transmitter is the ultimate FPV VTX giving you the option to adjust output power to fit your needs. This transmitter features the ability to adjust the transmission power, from 25mW, 200mW, or 600mW for long range. The lower 25mW and 200mW transmission power means more pilots can fly together without overpowering each other on close frequencies. The TX5GA has 32 channels and now includes the new Raceband frequencies. Our friends from ImmersionRC first divided the 5.8 band into 8 channels evenly spread out 37MHz from each other, which allows more racers flying at the same time on the same band. Lumenier Raceband transmitters are fully compatible with FatShark and ImmersionRC receivers.
The TX5GA features an easy to use single button, LED interface. It also comes with a clean pre-wired harness, and only weighs 12g. It’s perfect for a wide range of aircraft!
*Note: The metal housing acts as a heatsink and dissipates heat, mount in an area where there is good airflow. Do not power on the transmitter for long periods of time on the ground while on 600Mw mode without active cooling as the transmitter may overheat.
Features
32 channels: Cover F, E, A bands and R (Raceband) bands
Intuitive and easy to use button and LEDs for frequency and power selection
Small sized and light weight
Transmitter frequency: 5658-5925MHz with 25 - 600mW power output
Transmitting distance > ~2000m (open area at 600mW)
SMA Antenna connector
Dimensions: 38*28*9mm (not including SMA adapter)
Specifications:
Operating Voltage: 7 - 19V
Output Voltage: 5v
Supply current: ~220 mA
Operating Temperature: -10 +85 C
Video Band Width: 0-8.0 MHz
Audio carrier Frequency: 6.5 MHz
Video Input Level: 0.8,1.0,1.2 Vp-p
Video Input Impedance: 75 Ohm
Audio Input Level: 0.5 ,2.0 Vp-p
Audio Input Impedance: 10K Ohm
Weight: 12g (without antenna)
Antenna Connector:SMA Female Connector
Video Format: NTSC/PAL
Output Impedance: 50 Ohm
Output Power: 26, 26.5, 27 dBm
Frequency Selection: Single push to change CH, push and hold for 2 seconds to change FR
RF Power Selection: Press the PWR button once to change the output RF Power.
Operating Instructions:
How to change frequancies (Bands / Channels).
Press CH button once to change channel.
Push and hold CH button for 2 secounds to change band.
Press PWR button once to change output RF Power.
Compatible with Fatshark, ImmersionRC, Boscam, Foxtech and other generic branded FPV receivers within the same frequency range.
